RotoZip RZ1500 Specifications download pdf (Page 21)

Service

Preventive maintenance

performed by unauthorized

per so n nel may result in misplacing of

internal wires and components which

could cause serious hazard. We

recommend that all tool service be performed

by a Bosch or Rotozip Factory Service Center

or Authorized Bosch Service Station. Call 1-

877-ROTOZIP (1-877-768-6947) if your tool

needs service.

TOOL LUBRICATION

Your Rotozip tool has been properly lubricated

and is ready to use. The lubrication applied at

the factory lasts for the life of the tool.

CARBON BRUSHES

The brushes and commutator in your tool have

been engineered for many hours of

dependable service. To maintain peak

efficiency of the motor, we recommend every

two to six months the brush es be examined.

Only genuine Rotozip replace ment brushes

specially designed for your tool should be

used.

BEARINGS

Your Rotozip tool and attachments contain

sealed bearings designed to last the life of the

tool. Bearings which become noisy (due to

heavy load or very abrasive material cutting)

should be inspected at once to avoid

overheating or motor failure. Contact your local

Bosch or Rotozip Factory Service Center if

your bearings become noisy.

Cleaning

To avoid accidents always

dis connect the tool from

the power supply before cleaning or

performing any main tenance. The tool may

be cleaned most effectively with compressed

dry air. Always wear safety gog gles when

cleaning tools with compressed air.

Ventilation openings and switch levers must be

kept clean and free of foreign matter. Do not

at tempt to clean by inserting pointed objects

through openings.

Certain cleaning agents

and sol vents damage

plastic parts. Some of these are: gasoline,

carbon tetrachlo ride, chlo rinated cleaning

solvents, ammonia and house hold detergents

that contain ammonia.

!

WARNING

Maintenance

MAKING A CUT

1. Your jigsaw handle attachment is

equipped with a trigger switch. Slide the lock-

out lever (figure 7) to either side with your

thumb, then squeeze the trigger.

2. While holding the tool firmly, insert the bit

into the material at a 45° angle (figure 8).

3. Slowly bring it to a 90° angle to begin the

cut. The base plate should be flush to the

material surface (figure 9).

4. Release the trigger to de-activate your tool

after the cut.

!

WARNING

!

CAUTION

-21-

FIG. 8

FIG. 9

FIG. 7

LOCK OUT

LEVER

TRIGGER

RZ 2610011540 04-10:RZ 2610011540 04-10 4/7/10 8:17 AM Page 21

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 71 72

Comments to this Manuals

No comments